How to Identify a Faulty Submersible Pump System? 5 Signs to Watch Out!
Did You Know?
https://kaveripump.com/2022/07/29/blog-2/
“15% of the American population (43 million) obtain water from a private well. Maintenance and service are thus vital for the smooth operation of the equipment.”
U.S. Geological Survey (2021) Shallow well jet pumps use suction technology to build atmospheric pressure to pull water from the depth of 25 feet. Deep-well jet pumps have a jet mechanism installed at the well’s bottom. The jet forces the water through a two-pipe system in a circulatory motion. Such a pump is used for drawing water from a depth of over 25 feet.
A submersible well pump mechanism forces the water upwards than using suction. Installed in the water well, these compact pumps are more reliable and more efficient than their former jet pumps counterparts.
Faulty Submersible Pump Signs
1. Broken Seal: Often, lack of pressure suggests that the pump needs refilling with water. A broken mechanical seal, a leaking pressure tank, or a pipe can cause low pressure. To check the leakage, pressurize the pump and fill it with soapy water, the soap bubbles will instantly help to identify the leaks.
2. Low Pressure:
The pressure switch of the pump regulates the pressure, which is measured in PSI (pounds per square inch). When the pressure falls below the preset minimum limit, this mechanism is turned on. However, if the pressure exceeds the maximum limit, it turns off the pump. Usually, the preset range is between 20-40 PSI, 30-50 PSI, and 40-60 PSI.
A regular check of the pressure switch should be done. It should be clean and free from debris, as sand or dust particles can easily clog the switch’s sensor. Remember, to shut off electricity before you check the switch.
3. Air in the Pipes: If you discover a “spitting” sound as the water gushes out of the faucet, then the pump is the culprit. Perhaps, the Faulty Submersible Pump is installed at a higher altitude than the well’s water level. Hence, it’s pumping water poorly and simultaneously sucking up a lot of air. Perhaps, the pipes have a leak that is causing the air to mix with water. Consider hiring a plumber to inspect the plumbing system.
4. Leakage: If the coolant level falls below the earmarked level but there are no signs of a leak, check the oil dipstick. If it appears frothy, a possible leak is present in the Faulty Submersible Pump.
5. Continuous Running Pump: The pressure switch regulates the operation of the water pump. If this mechanism was not designed, the pump would run continuously, leading to quick burn and degradation of the pump’s motor, plumbing system, and stress on your energy bills. Further, an incessantly operational pump would burst the plumbing system, as it would fill the pressure tank above its handling capacity.
Subsequently, Some Faulty Submersible Pump have an alarm system that sends alerts if the pump operates excessively. Alternatively, keep a regular check on the pump’s functioning.
Conclusion:
Just like any machine prone to regular wear and tear with use, water pumps are no different. Preventive maintenance enables you to catch the problem early and nip it in the bud. Subsequently, you save a fortune on fixing it. Thus, regular checks, maintenance, and repairs are critical to the health of the water pump, if you want to enjoy an uninterrupted supply of water in your home.
